52
Technical data • Entire device
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.2 APC620, 2 PCI slot variant
2.2.1 Interfaces
Figure 10: Interface overview - APC620, 2 PCI slot variant (top)
Warning!
Do not remove mounting screws from the heat sink, as it is connected to the
processor and chipset by a thermal coupling. Should this connection be broken, the
APC620 must be sent for repair. Removal of the mounting screws, which can be
determined by a broken seal, voids all warranty.
During operation, surface temperatures of the heat sink may reach 70°C (warning
"hot surface").
VOID WARRANTY
IF SEAL BROKEN
060003861
COM 1
COM 2
Ethernet 1
Ethernet 2
USB 1, USB 2
MIC, Line IN,
Line OUT
PCI slot 1 half-size
PCI slot 2 half-size
Heat sink
Power
HDD
Link1
Link2
Heat sink seal
Warning
LED for:
Supply voltage
+24 VDC
Add-on interface slot
AP Link slot
1)
1) Can only be used with system unit 5PC600.SX02-00
Monitor / Panel
SDL (Smart Display Link) / DVI
Add-on UPS slot
2) Slot is only provided on 5PC600.SX02-00 devices with Rev. G0 or higher and 5PC600.SX02-01 with Rev. H0 or higher
2)
To Next Page
Loading...
