B&R Automation PC 620 - Status Leds Power, CF, Link (Only APC620 Embedded)

132
Technical data • Entire device
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.13.23 Status LEDs Power, CF, Link (only APC620 embedded)
The status LEDs are integrated in the system unit behind the orange front cover.
Figure 44: Front-side status LEDs
Status LEDs Power, CF, Link (only APC620 embedded)
LED Color Meaning
Power
Green On Supply voltage OK
Red On
The system is in standby mode
(S5: soft-off mode or S4:
Hibernate mode -Suspend-to-
Disk)
Orange
1)
1) Only lit when add-on UPS module is installed.
On
Supply voltage not
OK; the system is operating on
battery power.
CF Yellow On
Indicates access to
CompactFlash (read or write)
Link Yellow
On
Active SDL connection on the
monitor/panel connection
blink
ing
An active SDL connection has
been interrupted by a loss of
power in the display unit.
Off No active SDL connection
Table 60: Status LEDs Power, CF, Link (only APC620 embedded)