512
Maintenance / Servicing • Slide-in drive - installation and exchange
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
3.2 Exchange procedure
• Disconnect the power supply to the Automation PC 620.
• Touch the housing or ground connection (not the power supply!) in order to discharge any
electrostatic charge from your body.
• Remove the side cover, see section 5 "Mounting the side cover", on page 531.
• Simultaneously remove both slide-in slot releasing mechanisms outwards The slide-in
drive is pushed a few mm upwards for easy removal.
• Removing the slide-in drive.
Figure 271: Release the slide-in slot releasing mechanisms
Figure 272: Removing the slide-in drive
To Next Page
Loading...
