B&R Automation PC 620 - Page 302

302
Software • BIOS options
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
Interrupt Selection of the interrupt for the COM port. IRQ 5, IRQ 6, IRQ 7,
IRQ 10, IRQ 11
Selected interrupt is assigned.
CAN Configuration of the CAN port of the B&R
add-on CAN interface card
5AC600.CANI-00 (IF option).
Disabled Disables the interface.
Enabled Enables the interface.
Base I/O address Selection of the base I/O address for the
CAN port.
None -
Interrupt Selection of the interrupt for the CAN port. IRQ 10, NMI Selected interrupt is assigned.
ETH2 LAN controller For turning the onboard LAN controller
(ETH2) on and off.
Disabled Disables the controller.
Enabled Enables the controller.
ETH2 MAC Address Displays the Ethernet 2 controller MAC
address.
None -
BIOS setting Meaning Setting options Effect
Table 189: X945 Legacy Devices setting options (cont.)