356
Software • Automation PC 620 with Windows XP Professional
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
The internal serial interface COM C on the APC620 must be activated in BIOS (under Advanced
- Baseboard/Panel Features - Legacy Devices) for the Automation 900 devices' touch screens.
See the section 6.3.1 "Installation for Extended Desktop", on page 359 for information about
installing the touch screen driver.
A panel locking time can be set in the B&R Control Center to prevent simultaneous operation of
the Automation Panel 900 (see the .chm help file for the B&R Control Center).
Figure 162: Extended desktop settings - primary device and monitor
Information:
• The panel locking time is reset to the value configured in the key
configuration (KCF - Key Configuration File) when the system is restarted.
To Next Page
Loading...
