Maintenance / Servicing • Fan kit installation and replacement
Section 7
Maintenance / Servicing
501Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
• The fan connection cable must be connected to the main circuit board at the right position
(fan 1 at position 1, fan 2 at position 2).
• If one or more PCI cards were previously in place, they can now be re-inserted.
• If a slide-in drive was previously in place, it too can now be re-inserted.
• Place the dust filter in the fan kit cover and secure with the filter clasp.
• Replace any removed components (filter kit cover, side cover) in the reverse order.
Figure 254: APC620 2PCI slots - Fan cable connection to the main board
Figure 255: Dust filter in the fan kit cover and filter clasp
Filter clasp Dust filter
Fan kit cover
To Next Page
Loading...
