Barco DP2K SLP Series

R5906848 /04 DP2K SLP Series 269
Ref.
Description (LED
color)
LED Ref. Comment
• Drain current overload of bank 2
3 red Leds are on when :
• enable line is low (from Laser Control Board)
• temperature of heatsink drain is high
• temperature of heatsink rectifier is high
6 Bank 1 ON (green) D477 Lit up when laser driver 1 is running
7 Bank 1 warning or
error (red)
• warning: red led
on, bank is still on
(green led on)
• error: red led on,
bank is turned off
(green led off)
D476 This red led is on when 1 of following parameters is out of range:
• Temperature of laserbank 1 is high
• Rectifier current overload of bank 1…)
• Laserbank voltage
• Rectifier voltage of laserbank 1
• Drain voltage of bank 1
• Drain power overload of bank 1
• Drain current overload of bank 1
3 red Leds are on when :
• enable line is low (from Laser Control Board)
• temperature of heatsink drain is high
• temperature of heatsink rectifier is high
Board Diagnostic LED's