R5906848 /04 DP2K SLP Series 75
9. Install the light source back into the projector. See “Installing the Light Source”, page 67.
7.13 Replacing the Blue Laser Interconnection
Board
How to replace the interconnection board?
1. Remove the Light Source from the projector frame. See “Removing the Light Source”, page 61.
2. Release the protective cover of the Blue Laser interconnection board. Use a PH1 Phillips screwdriver to
loosen the 3 screws.
Image 7-33
3. Remove the wire units connected to the interconnection board.
4. Replace the Blue Laser Board as illustrated. Use a PH1 Phillips scerwdriver to loosen and tighten the screws.
Image 7-34
5. Reconnect the wire unit to the Light Sensor Interconnection board.
6. Place the protective cover back over the Blue Laser Interconnection Board. Use a PH1 Phillips screwdriver to
tighten the three screws.
7. Install the light source back into the projector. See “Installing the Light Source”, page 67.
7.14 Replacing a fan from the Light Source
Required tools
• Allen wrench 3 mm
• Phillips screwdriver PH1
Laser Phosphor Light Source
To Next Page
Loading...
