To Next Page

To Previous Page

R5906848 /04 DP2K SLP Series364

Code 20414: “LDM 1-6 – Not configured (initialization failure)”

For this error the same troubleshooting table can be applied to as for code 20279: “LDM 1 – Not configured

(initialization failure)”.

Code 20425: “LDM 1-7 – 24V LCB voltage low”

Situation Solution

Wiring issue Check the cable between LCB and the 24V filter board on the one end,

and the cable between the filter board and the +24V module of the LDM

(LDM slot 7). Replace if necessary.

Malfunction 24V filter board. Replace the 24V filter board. See service procedure “Replacing the 24V

Filter board”, page 65.

Code 20426: “LDM 1-7 – 24V LCB voltage high”

For this error the same troubleshooting table can be applied to as for code 20425: “LDM 1-7 – 24 V LCB

voltage low”.

Code 20431: “LDM 1-7 – Heatsink rectifier temperature too high”

For this error the same troubleshooting table can be applied to as for code 20377: “LDM 1-2 – Heatsink

rectifier temperature too high”.

Code 20432: “LDM 1-7 – Heatsink rectifier temperature sensor shorted”

For this error the same troubleshooting table can be applied to as for code 20378: “LDM 1-2 – Heatsink

rectifier temperature sensor shorted”.

Code 20433: “LDM 1-7 – Heatsink rectifier temperature sensor open”

For this error the same troubleshooting table can be applied to as for code 20379: “LDM 1-2 – Heatsink

rectifier temperature sensor open”.

Code 20436: “LDM 1-7 – Not configured (invalid module type)”

For this error the same troubleshooting table can be applied to as for code 20278: “LDM 1 – Not configured

(invalid module type)”.

Code 20437: “LDM 1-7 – Not configured (no communication)”

Situation Solution

Mismatch in driver boards

mounted in the LDM

Check if the +24 V module is in the correct slot (LDM 1-7).

Code 20438: “LDM 1-7 – Not configured (initialization failure)”

For this error the same troubleshooting table can be applied to as for code 20279: “LDM 1 – Not configured

(initialization failure)”.

Code 20523: “LDM 1-3 – LLS bank 4 drain voltage too high”

For this error the same troubleshooting table can be applied to as for code 20323: “LDM 1 – LLS bank 1 drain

voltage too high”.

Code 20527: “LDM 1-3 – LLS bank 5 drain voltage too high”

For this error the same troubleshooting table can be applied to as for code 20323: “LDM 1 – LLS bank 1 drain

voltage too high”.

Troubleshooting

Brand	Barco
Model	DP2K SLP Series
Category	Projector
Language	English

Barco DP2K SLP Series Service Manual

Table of Contents

Other manuals for Barco DP2K SLP Series

Questions and Answers:

Barco DP2K SLP Series Specifications

Related product manuals