Disposal
Manual b maXX
®
BM1000
Document No. 5.07003.04
115
of 174
12
12.3 Disposal instructions
Preconditions m The device has already properly been demounted.
m All technical appliances for demounting are prepared and are technically in good order
and condition.
12.3.1 Modules
Sheet steel Sheet steel must be given to the iron metal recycling.
Aluminium Aluminium must be given to the non-iron metal recycling.
Aluminium/cop-
per compound
Aluminium/copper compound must be given to the non-iron metal recycling.
Plastics The plastic parts of the housing as well as the plastic covers and further small plastic parts
must be given to the plastics recycling.
Capacitors Capacitors are to be recycled as special waste. Thereby refer to the relevant instructions.
Semiconductor
modules
Semiconductor modules are to be recycled as special waste. Thereby refer to the relevant
instructions.
Electronic scrap The electronic scrap from PCBs, which no further can be demounted, must be recycled
as special waste. Thereby refer to the relevant instructions.
12.4 Recycling plants/offices
Assure, that the disposal is carried out according to your company’s regulations and the
regulations of the disposal companies and official administrations. In case of doubt, con
-
tact the local business administration, which is responsible for your company or the envi-
ronmental office.
CAUTION
The following can occur, if you disregard this warning instruction:
m Environmental pollution
The danger is: incorrect disposal.
Capacitors, semiconductor modules and electronic scrap is to be recycled as special waste.
To Next Page
Loading...