Error detection and troubleshooting
Manual b maXX
®
BM1000
Document No. 5.07003.04
89
of 174
8
8.5 Reset
There are three methods to reset the device after solving the fault:
m Press key on keypad.
m Set external terminal to „RESET“ (set one of P1091 to P1094 to 05) and then set to be ON.
m Send „RESET“ command by communication.
NOTE
Make sure that RUN command or signal is OFF before executing RESET to prevent damage
or personal injury due to immediate operation.
To Next Page
Loading...
