Inappropriate use
Manual b maXX
®
BM1000
Document No. 5.07003.04 Baumüller Nürnberg GmbH
18
of 174
2.6
2.6 Inappropriate use
Listed below you will find some examples of non-appropriate application. The information
below is intended to give you some impression of what non-appropriate application is.
However we cannot state all possible non-appropriate applications here. All applications,
where the notes and information given in this documentation is disregarded, are non-ap
-
propriate and therefore forbidden.
Examples:
m You disregarded the notes in this manual.
m The device has not been specifically applied as a converter in order to control a motor.
n The device has been
m mounted incorrectly,
m connected incorrectly,
m commissioned incorrectly,
m operated incorrectly,
m mounted, connected, commissioned, operated and/or maintained by not qualified or
inadequately qualified personnel,
m inappropriately maintained or not maintained
(also consider the descriptions of the components),
m overloaded it,
n operated
m with defective safety devices,
m with incorrectly mounted safety devices or without safety devices,
m with incorrectly working safety- and protection devices,
m outside the specified environmental conditions.
m You have modified the device.
m You have insufficiently monitored the parts, which are subject to a wearing.
m You have improperly carried out a repair.
m You have combined the device with improper products, which are not enabled for de-
vices described in this manual.
m You have combined the device with faulty and/or faulty documentated products of oth-
er manufacturers.
m The device has been operated in an explosive environment.
2.7 Safety equipment
The devices b maXX
®
BM1000 comply with the protection class IP 20.
WARNING
The following may occur, if you do not observe this warning information:
m serious personal injury m death
The danger is: electricity.
Operate the device in a control cabinet, which provides a protection against a direct touching
of the devices and fulfills at least the demands of the EN61800-5-1, chapter 4.2.3.3.
To Next Page
Loading...
