Baumuller b maXX BM1000 - Definition of the Term Declaration of Conformity; Definition of the Term Manufacturers Declaration

Definition of the term Declaration of Conformity
Manual b maXX
®
BM1000
Document No. 5.07003.04 Baumüller Nürnberg GmbH
138
of 174
C.3
With specified application of this Baumüller equipment in your machinery, you can act on
the assumption that the equipment satisfies the requirements of 98/37/EG (machinery di
-
rective). Therefore the equipment is developed and constructed in such a way, that the
requirements of the harmonized standard EN 60204-1 can be met by the electrical instal
-
lation.
Compliance with 89/336/EEC (EMC Directive) depends on how the equipment is in-
stalled. Since you are performing installation yourself, it is you who are responsible for
complying with 89/336/EEC.
A declaration of conformity on the EMC directive therefore cannot be issued.
We will provide you with support in the form of EMC information. You will find this infor-
mation in the operating manual and in “filters for main applications”. When you have com-
plied with all the requirements we impose in this documentation, you can assume that the
drive satisfies the requirements of the EMC Directive.
The limit values and requirements for variable-speed electrical drives are determined in
the harmonized product standard EN61800-3. If you are erecting an installation, for which
a declaration of conformity on the EMC directive must be generated, it may be necessary
to specify several harmonized standards, which you have used for the compliance of the
protection targets of the directive. The harmonized product standard EN 61800-3 has to
be used with electrical drives.
To enable you to market your machine within the EU, you must be in possession of the
following:
m Conformity mark (CE mark)
m Declaration(s) of Conformity regarding the directive(s) relevant to the machine
C.3 Definition of the term Declaration of Conformity
A Declaration of Conformity as defined by this documentation is a declaration that the
electrical equipment brought into circulation conforms to all the relevant fundamental
safety and health requirements.
By issuing the Declaration of Conformity in this section the Baumüller Nürnberg GmbH
declares that the equipment conforms to the relevant fundamental safety and health re
-
quirements resulting from the directives and standards which are listed in the Declaration
of Conformity.
C.4 Definition of the term Manufacturer’s Declaration
A Declaration by Manufacturer as defined by this documentation is a declaration that the
machine/safety component brought into circulation conforms to all the relevant funda
-
mental safety and health requirements.
By issuing the Declaration of Conformity in this section the Baumüller Nürnberg GmbH
declares that the equipment conforms to the relevant fundamental safety and health re
-
quirements resulting from the directives and standards which are listed in the Declaration
of Conformity .
The Baumüller equipment is integrated into a machine. For health and safety, of the users
for example, it is important for the entire machine to conform to all the relevant fundamen
-
tal safety and health requirements. For this reason the Baumüller Nürnberg GmbH draws
attention in the Declaration by Manufacturer to the fact that it is prohibited to put the ma
-
chine as a whole into operation before it has been declared that the machine conforms to
the provisions of the Machinery Directive.