Declaration of Conformity/Manufacturer, UL - Certification
Manual b maXX
®
BM1000
Document No. 5.07003.04
139
of 174
C
C.5 UL-certification
UL is a mark of conformity, which is assigned from Underwriters Laboratories Inc. (www.ul.com), an
American company. The UL-certification is not statutory regulated, but takes place voluntarily.
In order to be allowed to mark equipments and components with the UL-mark of confomity, tests must
have to be done, which are attended and documentated by an UL-inspector. Only if all necessary tests
have been passed and regular product monitoring at the production process of the equipment or the
components has been passed without objections, the UL-mark of conformity may be attached to the
equipment under test.
Line filters of the company Baumüller Nürnberg GmbH are checked in accordance of the UL-standard
UL 508C (UL-Standard for Safety for Power Conversion Equipment) and are recorded under the cate
-
gory control number NMMS. The product- and test description is recorded under
file-no. E179860.
Only if all necessary tests have been completely carried out the c-mark may be attached to the equip-
ments or components. If single tests have not already taken place at the manufacturer´s, but are carried
out not until at the user´s, then only the u-mark may be attached.
With products of the Baumüller Nürnberg GmbH all tests are already completed at the UL-certification
process, so that they may be marked with the c-mark.
In case with the UL-certification process also standards of the CSA (Canadian Standard Association)
are considered, then instead of the c- or u-mark the
cc or U-mark may be attached to the prod-
uct.
With products of the company Baumüller Nürnberg GmbH the CSA-standard Norm C 22.2 was consid-
ered, that´s why they are marked with the cc-mark.
If products of Baumüller Nürnberg GmbH are mounted into an UL-certified installation, then certain ap-
plication-, mounting- and installation notices must be considered, which are upon the functioning of the
device. We have marked these notes in the manual with „UL 508C ...“. Only if you follow these notes
and apply to them you may go by it, that the installation has been mounted UL-conform.
To Next Page
