Baumuller b maXX BM1000 - 5 Mounting; General Safety Instructions

33
of 174
Manual b maXX
®
BM1000
Document No. 5.07003.04
5MOUNTING
In this chapter we describe the mechanical mounting of the device into a control cabinet.
Data about the installation space is available in this manual (see
ZInstallation space–
from page 36).
Mounting consists of the following steps:
1 Prepare mounting (drill holes/cut-out segments)
2 Install device
5.1 General safety instructions
h Please regard to the information in chapter ZFundamental safety instructions– from
page 11.
WARNING
The following may occur, if you do not observe this warning information:
m serious personal injury m death
At execution of any mounting workings it must be assured that no strange substances (e.g.
drilling chips, copper wire etc.) get into the device. If possible the drillings should be done be
-
fore mounting the device and the assembling of the cables should be done outside the control
cabinet. If this is not possible, the device must be covered accordingly.
CAUTION
The following may occur, if you disregard these safety notes:
m Property damage
The danger is: electrostatic discharge. Connections of the device sometimes are danger-
ous to ESD.
Regard the corresponding notes.