Requirements to the executing personnel
Manual b maXX
®
BM1000
Document No. 5.07003.04 Baumüller Nürnberg GmbH
44
of 174
6.2
6.2 Requirements to the executing personnel
At each case qualified personnel are persons, who are authorized by the responsible per-
sons, to execute necessary actions and who recognize the possible dangers and who are
able to avoid these dangers. They have had the training, the experience, they were given
instructions as well as knowledge about the relevant standards and instructions, they
have knowledge of the accident prevention regulations and of the operating environ
-
ments. The required qualifications for the work with this unit are for example:
m Education or instruction or to have the authorization to put into operation, ground and
label circuits and devices according to the standards of safety engineering.
m Training or instruction due to the standards of the safety engineering in maintenance
and use of appropriate safety equipment.
6.3 Requirements to the electrical mains
All important data is to be found in ZD.3 Electrical data– on page 143. Small deviations
of the electrical mains from the requirements can lead to malfunctions of the device. In
case the mains deviates strongly from the requirements, the device can be destroyed.
b
maXX
®
BM1000-devices must not be operated in low-voltage mains in order to supply
buildings in residential areas. The destruction of the device can cause personnel injury.
WARNING
The following may occur, if you disregard these safety notes:
m serious personal injury m death
The danger is: electricity. When operating with this electrical unit, inevitably certain parts of
this unit are under dangerous voltage.
Make sure, that only qualified personnel, who are familiar with the safety- as well as with
mounting-, operating- and maintenance instructions, work on this unit.
WARNING
The following may occur, if you disregard these safety notes:
m serious personal injury m death
The danger is: electricity. In case you do not ensure the requirements to the electrical mains,
the device can be damaged/destroyed and can thereby endanger persons severely.
Assure before installation, that the requirements of the electrical mains are fulfilled.