Baumuller b maXX BM1000 - Training of the Personnel; Safety Precautions in Normal Operation; Dangers Due to Residual Energy

Fundamental safety instructions
Manual b maXX
®
BM1000
Document No. 5.07003.04
19
of 174
2
2.8 Training of the personnel
Qualified personnel (professionals) is defined below:
Qualified
personnel
Authorized electronic engineers and skilled persons of the customer or third persons, who
have learned the installation and commissioning of Baumüller drive systems and who are
authorized, to put circuits and devices into operation according to the standards of the
safety technology, to ground and to label.
Qualified personnel has a training or an instruction due to the local valid standards of the
safety technique in maintenance and usage of an adequate safety equipment.
Requirements to
the operating per
-
sonnel
The operating of the drive system must only be executed by persons, who have had a
training, who have been instructed and who have been authorized for this.
Fault clearance, servicing, cleaning, maintenance and exchange must only be carried out
by skilled or instructed personnel. These persons must know the operating manual and
must act according to this.
The commissioning as well as the instruction must only be carried out by qualified per-
sonnel.
2.9 Safety precautions in normal operation
h at the location of your appliance regard the safety regulations for the plant, into which
the appliance has been built in.
h if safety regulations require additional monitoring or safety devices supply your appli-
ance with them.
2.10 Dangers due to residual energy
Electrical
residual energy
After separation of the device from the mains parts under voltage as e. g. power connec-
tions may be only then touched if the capacitors in the device are discharged. To prevent
personal injury, please ensure that power has been turned off before opening the
b
maXX
®
BM1000 and wait ten minutes for the capacitors to discharge to safe voltage
levels.
Mechanical
residual energy
The mechanical residual energy is dependent upon the application. As we don't know the
application, we cannot make any exact statements. Driven parts also rotate/move after
disconnection of the mains supply for a certain time. Please, provide adequate safety ar
-
rangements.
WARNING
The following may occur, if you do not observe this warning information:
m serious personal injury m death
Devices of the company Baumüller Nürnberg GmbH may only be assembled, installed,
operated and maintained by qualified personnel.