Belarus 820 - Page 20

80-0000010B OM
20
Table 1.2.1 finished
Parameter
(characteristics) title
Parameter value for tractor
80.1 82.1 820
22 Working equipment:
а) rear power take-off shaft:
1) rated speed of PTO shaft
end with the continuous drive
on, min
-1
:
- position I (under the engine
crankshaft speed 2081 min
-1
)
540
- position II (under the engine
crankshaft speed 2187 min
-1
)
1000
2) rated speed of PTO shaft
with the ground-speed drive on,
rev/meter of travel
3,44
3,44 3,36
b) side semi-continuous power
take-off shaft:
1) rated speed of PTO shaft
end (under the engine crankshaft
speed 2200 min
-1
) with gear re-
duction unit engaged, min
-1
:
571
2) rated speed of PTO shaft
end (under the engine crankshaft
speed 2200 min
-1
) with gear re-
duction unit disengaged, min
-1
:
765
c) rear lift linkage:
1) load capacity of rear lift link-
age on suspension axis, kg, not
less than 3200
2) time for raising rear lift
linkage from lowermost position
into uppermost position with test
load (80050) kg on suspension
axis, under maximum engine
crankshaft speed, sec., not more
than
3
d) tow hitch: In section 5 “Coupling of implements”
1
)
Engine parameters, not specified in table 1.2.1., shall correspond to 243-0000100
OM, 243C/245C-0000100 OM document.
2)
For referential use.
3)
Without a creeper.
4)
Specified depending on the configuration.
5)
Permissible deviations ± 50 kg.