80-0000010B OM
27
- as you move the lever of the switch 1 from the lower beam position up against the
stop, the upper beam turns on for a short time (“upper beam blinking, non-fixed position) irre-
spective of the position of the central light switch. As you release the lever it will automati-
cally return to the lower beam position.
Pressing the emergency flashing switch 2 (fig. 2.2.1) activates the emergency flash-
ing. A pilot lamp, built in the button, flashes simultaneously with the emergency flashing
lights. Repeated pressing button 2 deactivates the emergency flashing.
Central light switch 3 (fig.2.2.1) has three positions:
- position “I” – “off” (the upper part of the button is pressed as in fig 2.2.1);
- position ”II” – “front and rear parking lights, license plate lights, lighting of instruments on
the dashboard and also parking lights on a trailed machine are on” (middle position);
- position “III” – “all consumers of “II” position and road headlights are on” (lower part of
the button is pressed against the stop as in fig. 2.2.1).
Pressing button 4 (Figure 2.2.1) (non-fixed position) turns the windscreen washer
on. Releasing button 4 turns the windscreen washer off.
To Next Page
Loading...
