80-0000010B OM
279
6.2.3 Providing access to tractor components for technical maintenance of tractors
with metal hood 90-8400005.
Before starting technical maintenance, it is required to remove the monocyclone and
raise hood 6 (figure 6.2.3).
To remove the monocyclone, pull it upwards.
To raise hood 6, do the following:
- release lock 8 from engagement with binder 9 by pulling handle 7;
- raise hood 6;
- fix hood 6 in open position with the help of rod 3 in bracket 4.
WARNING: BEFORE STARTING TECHNICAL MAINTENANCE IN THE AREA UN-
DER THE HOOD, MAKE SURE IT IS SECURELY FIXED IN THE OPEN POSITION!
To provide access to units and parts that are located directly under hood 6 (in closed
position) in the tractor front part, do the following:
- unscrew bolts 1 in two places;
- remove mesh 2.
To install mesh 2 on hood 6, do the following:
- mount mesh 2 and fasten with bolts 1 in two places.
To lower and close hood 6 proceed as follows:
- slightly raise hood 6 in order to free rod 3 from bracket 4;
- fix rod 3 in clamp 5 on hood 6;
- lower hood 6 to its bottom position until you hear a typical click (actuation of lock 8).
1 – bolt; 2 – mesh; 3 – rod; 4 – bracket; 5 – clamp; 6 – hood; 7 – handle; 8 – lock;
9 – binder; 10 – bracket; 11 – detent.
Figure 6.2.3 – Diagram of the mechanism to raise, lock and lower the hood.
To Next Page
Loading...
