220
THIS IS AN UNCONTROLLED DOCUMENT.
THIS ELECTRONIC DOCUMENT MAY HAVE BEEN SUPERCEDED.
THE MOST CURRENT DOCUMENT INFORMATION IS AVAILABLE
FROM YOUR BELL HELICOPTER TEXTRON REPRESENTATIVE.
PRODUCT DATA JANUARY 2003
The snow baffle kit, when installed alone or with the particle separator kit, permits
operations in falling or blowing snow. The kit consists of a deflector shell for each
engine air inlet. Provisions for installation of the baffles are part of the standard
configuration, and are located on the
transmission fairing in front of each air inlet.
Operating procedures are found in the FAA approved Flight Manual Supplement BHT-
430-FMS-20. The baffles are approved for operation at temperatures up to +20°C (68°F),
above which they shall be removed. The Weight increase with the baffle kit installed is
1.7 kilograms (3.8 pounds).
SNOW BAFFLES
NO. 230-706-502-XXX
To Next Page
Loading...
