!
222 ATOMLAB 500 DOSE CALIBRATOR
DT {#}
Display or Set the Date/Time. If no parameter is given, the current Date/Time is displayed in US
24hr format. For setting the date/time, the display's current date/time is updated and the
real-time clock updated. The date/time parameter must be in standard us 24hr format as
follows: mm/dd/yyyy hh:mm:ss
ECHO {1/0}
Display or turn local character echo ON (=1) or OFF (=0). Local character echo is on by default. If
using data streaming, this should be turned OFF to avoid mangling the streaming reports.
HELP
Same as the “?” command, displays all available commands with a brief description.
ISO {#}{-#}
(For a Dose Calibrator Only)
Displays or sets the isotope assigned to a detector. For a single detector system, the 2nd
parameter is not required. The 1st parameter is an isotope index number, 1 to 88 for the default
isotopes, 89 to 113 for custom isotopes. Refer to the separate isotope index document at the end
of this chapter for details. The 2nd parameter is the detector number. If no parameter is given,
the current assigned isotope for each detector is displayed. Use this command with great care - if
the display is in use doing a QA test, this command can corrupt the current running test.
Example of a command:
ISO 43 {sets isotope Tc-99m for detector #2}
The Following errors may be returned:
ERROR: Invalid isotope index # {a number greater than 90 was specified}
ERROR: Measure Screen Not Active {The Measure screen must be on view for this command
to work}
When this command is received, the newly selected isotope will be displayed, and the activity
changed accordingly. However if any screen other than the Measure screen is on view, the
isotope cannot be changed, and the displayed screen will not be affected.
NOTE: Reference Isotope Index # Table for programming.
PRTSCR
Prints the current displayed screen on the HP inkjet printer
PWD {1/0}
Sets the screen password override (1=Override, 0=entry required). If no parameter is given, the
current state of the password override is displayed.
QADATA
Displays a summary of stored QA Data Records. For each QA data type, the allocated space and
used space is shown.
To Next Page
Loading...
