Biolight Meditech P1 - Page 205

P1 Patient Monitor User’s Manual
17-2

2. Select 【Network Setup】 submenu  【LAN】 submenu.
3. Select how to get the IP address:

【 Obtain IP Address Automatically 】 : The monitor automatically
gets the IP address.
 【Use the Following Address】: you need to input the 【IP Address】,
【Subnet mask】 and 【Gateway】.
17.2.3. Setting the Wireless network
To set the wireless network, follow this procedure:
1. Select【Network Setup】quick key.
2. The interface will show the surrounding wireless network, and you can
choose to use the wireless network according to your needs.
3. If you need to manually add a wireless network, you can select the 【Add
Net】 button at the bottom of the menu to set the 【SSID】, 【Security】,
【Password】 and 【DHCP】 of the network:
 【SSID】：Set name of the network.
 【Security】：Set the encryption method.
 【Password】：Set the password to enter the network.
 【DHCP】：Open 【DHCP】, and the monitor will automatically
acquire the IP address; if close 【DHCP】, you need to manually enter
the IP address, subnet mask and gateway.
17.2.4. Setting the wireless network frequency and antenna type
The steps for setting the wireless network frequency and antenna type are as follows:
1. Select【 Main Menu】 quick keyfrom【 System】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select 【Network Setup】 submenu  【WLAN】 submenu.
3. Set the 【Frequency】 and 【Antenna】 of the wireless network according
to the usage.
 【Frequency】:【5G】 or 【2.4G】.