P1 Patient Monitor User’s Manual
17-3
【Antenna】: 【Build-in】 or 【External】.
4. Restart the monitor
17.2.5. Connecting the Central Monitoring System (CMS)
The monitor can be connected to the central monitoring system via wired network or
wireless network.
17.2.5.1. Setting the CMS IP Address
To set the IP address of CMS, follow this procedure:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select 【Network Setup】 submenu 【CMS】 submenu.
3. Set the IP address of the CMS. The monitor can be received by the CMS
of the IP address.
17.2.5.2. Setting the device number of the monitor
The device number of the networked monitor will be displayed when the central
monitoring system and other beds are monitored. The steps for setting the device
number of the monitor are as follows:
1. Select 【 Main Menu】 quick keyfrom 【 System】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select 【Network Setup】 submenu 【CMS】 submenu.
3. Set 【Device No.】 of the monitor.
Please refer to the Central Monitoring System User’s Manual for detailed
instructions.
NOTE:
This monitor can only be connected to the central monitoring system provided
by the manufacturer. Do not try to connect the monitor to other central
monitoring system.
To Next Page
Loading...