Biolight Meditech P1 - Page 77

P1 Patient Monitor User’s Manual
7-9

3. Set【Alarm Delay】.
The delay time of the apnea alarm is not affected by the alarm delay time setting.
You can set the delay time of the apnea alarm separately.
7.7.4.1. Setting Apnea Alarm Delay Time
Steps to set apnea alarmdelay time are as follows:
1. Enter 【 Setup 】 interface in either of the following ways:
 Select
【 Alarm Setup 】 quick keySelect 【 Setup 】 submenu.
 Select 【 Main Menu 】 quick keyfrom 【 Alarm 】 column to select
【 Setup 】 .
2. Select【Apnea Delay】to set apnea alarm delay time.
7.7.5. Setting Alarm Waveform Length
You can set the length of the waveform needs to be output when an alarm occurs, the
setting steps are as follows:
1. Enter【Setup】interface in either of the following ways:
 Select【Alarm Setup】quick keySelect【Setup】submenu.
 Select【Main Menu】quick keyfrom 【Alarm】 column to select
【Setup】.
 Select【Main Menu】quick keyfrom【Report】column to select
【Record Setup】.
2. Set【Alarm Record Duration】.
7.7.6. Setting CMS and eGateway Disconnect Alarm Switch
You can set whether to alarm when the monitor and the CMS or eGateway are
disconnected. This function is enabled by default. The setting method is as follows:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select【Alarm】submenu【Other】submenu.
3. Open or Close 【CMS/eGW
Disconnected】.