Checksum Evaluates the checksum of the newly installed firmware.
The messages window shows “Checksum (addresses)” .. and after a short period of time “ok”. This
is a short form of the “Verify” process.
Stop Update Finishes upgrading.
The messages window shows “Finishing (addresses)" .. and after a short period of time “ok”. The
remote amps quit the update mode and start in normal mode.
Now, you can exit the upgrade dialog or proceed with upgrading other remote amps.
– If “Time Out” errors still occur during the programming, repeat the procedure in single step mode in the following
sequence: Start Update - Pro- gram.
– If the checksum evaluation shows errors, repeat the entire upgrade procedure. Don’t forget to uncheck “Single
Step” mode, for the upgrade to run automatically.
IRIS-Net REMOTE AMPLIFIER | en 175
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
Need help?
General
