RCM-810
Using RCM-810 remote amplifiers
The IRIS-Net software (Intelligent Remote & Integrated Supervision) runs under Windows and allows configuring, cont-
rolling and monitoring a complete PA-system from a single or from several PCs. Any operational status, e.g. power-on,
temperature, limiting, activation of protections, deviation of the output impedance, etc., are centrally recorded and
displayed, which offers the opportunity to react and interfere even before the occurrence of critical operational states.
Programming automated actions that are carried out when exceeding or falling short of certain threshold values is
possible as well. All parameters, e.g. power-on/off, mute etc. are controlled in real-time and can be stored in any power
amplifier. Monitoring the connected loudspeaker systems is performed by continuously measuring output currents and
voltages of individual power amplifier channels. Each exceeding or falling short of set thresholds is instantly signaled
and logged. In this way, short-circuits or line interruptions, as they might occur during normal operation, are
recognized and displayed immediately.
Furthermore, the RCM-810 provides a control port with freely programmable control inputs and control outputs.
Control inputs (GPI's) allow the connection of switches. IRIS-Net offers the possibility to program a variety of logic
functions for the inputs. Control outputs (GPO's) allow the connection of external components, which, for example,
are used to signal specific states to peripheral equipment. Consequently, an amplifier with a RCM-810 module installed
corresponds to highest safety requirements.
IRIS-Net REMOTE AMPLIFIER | en 288
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
Need help?
General
