Master Fault
Error
Description
Collected Error State The FAULT-LED on the front panel of the N8000 lights at the occurrence of this error.
Audio Processing General DSP fault, please refer to the table DSP Faults for further detail
Remote Amplifiers General Remote Amplifier fault, please refer to the table RCM Faults for further detail
Audionet Error within the Audionet-System (CM-1, DM-1, OM-1)
DPM 4000 The DPM 4000 connected to the RS-232 port cannot be accessed
CAN Bus General CAN Bus error, please refer to the table RCM Faults for further detail
Slave Devices A Remote Device signals an error or cannot be accessed
User Fault The Error Code of at least one User Fault has been set to ≠ 0
Watchdog from Master The Heartbeat Timer‘s time limit has been exceeded
AD Converter Malfunction in the A/D converter of control inputs (GPI)
Supply Voltages Error in the N8000’s internal power supply
GPI The input voltage of a control input (GPI) is to low/high
RS-232 Ports A unit connected to the RS-232 shows a malfunction
Configuration Data
Fault
Memory/Configuration data error, please refer to tables DSP Faults and RCM Faults for
further detail
Hardware
Configuration
Hardware Configuration fault in the N8000, please refer to table DSP Faults for further detail
IRIS-Net DIGITAL MATRIX | en 496
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
Need help?
General
