– Delay
– Polarity
– Look-ahead Peak limiter with Peak RMS detection
– TEMP Limiter for long-term loudspeaker protection
– Level & Mute
– 24-bit, 48kHz D/A converters
– Pilot tone generator
– VU Metering
– Output assignment display LEDs; sub, low, mid & high
– Mute button
– Gain reduction meters
ADDITIONAL FEATURES INCLUDE:
– Electronically balanced XLR inputs and outputs
– XLR thru connectors (analog + AES/EBU)
– -6 dB switchable input level PAD
– Test generator (Sine, pink noise, white noise)
– Contact closure interface
– USB port (front) and Ethernet port (rear) for connection to PC with IRIS-Net software; preset editing and real time
parameter control and monitoring.
– Firmware updates via USB port or Ethernet port
– FLASH memory for preset storage and firmware upgrades
– 192 x 32 back-light graphic LCD display
– LCD navigation / editing controls
– DSP block direct access controls
– Auto-ranging internal power supply; 100-240 V AC, 50-60 Hz
– Standard IEC A.C. inlet with external, replaceable fuse
Dx46 Device
Start by creating an Dx46 Device in your IRIS-Net project. Drag an Dx46 from the Object Bar’s Devices category or from
the Devices window into the worksheet (see also chapters: Devices and Configurations menu). Selected devices can be
dragged around and repositioned at will. To select a device either click and drag the mouse to draw a rectangle around
it or hold down the Ctrl key and click on the device. In either case a successfully selected device is shown with a red
border around it.
Double clicking on an Dx46 device icon opens the User panel.
IRIS-Net DIGITAL SOUND PROCESSOR | en 650
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
