Setting Up
¡
2-3
Users in countries outside North America may need to supply their own
power cord to meet the specifications required in individual countries.
For information on power cord requirements, refer to International
Power Cords on page viii in this guide.
Installing supplies
The next step in setting up your printer is installing a ribbon cartridge
and a tape cartridge. Your system reads information stored in the
memory cell flag located on each ribbon and tape cartridge, and uses
that information when you compose a label and when you print a label.
Hint! Before composing a label, install the supplies you want to use for
printing the label. You may change supplies during the label
composition process, but you then may have to make length or
color adjustments to your label before you can print it.
The system reads the memory cells on the cartridges every time you
open and close the printer, whether you install new supplies or not, and
when you print a label.
To Next Page
Loading...
Need help?
General
