2-6
¡
Installing supplies
Adjusting the ribbon cartridge
If a ribbon cartridge has been stored outside the printer, the ribbon
between the take-up spool and the wiper may have been exposed to dust.
The dust on the ribbon may transfer to the print head causing streaks or
scratches on your labels.
When a ribbon cartridge has been stored outside the printer, before
installing it, you should first advance the ribbon approximately 2 inches
(or 250 millimeters) counterclockwise, as shown in Figure 2-4.
Figure 2-4. Adjusting the ribbon cartridge.
This will prevent any dust that may have accumulated on the ribbon
from transferring to the print head and affecting how your labels print.
To Next Page
Loading...
