Broadcom Brocade DCX 8510-4 Backbone User Manual

53-1002177-19 Hardware Installation Guide Brocade DCX 8510-4 Backbone Hardware Installation Guide
switch:admin> login
login: admin
password: xxxxxxxx
switch:admin>
NOTE
If you are using the Virtual Fabric feature, you must run configdownload -vf before running the
configdownload command to restore the logical switch configuration.
2. Enter the chassisDisable command.
3. Enter the configDownload command.
switch:admin> configdownload -all
Server Name or IP Address [host]: 123.123.123.123
User Name [None]: Admin24
File Name [config.txt]: config-switch.txt
Password: xxxxxxxx
download complete
switch:admin>
4. Reboot the device.
Reconnecting the system to the network and fabric
Refer to the cable routing information recorded in Cable Routing table in this section for the following steps.
Complete the following steps to reconnect the device to the network and fabric.
1. Connect the CP blades to the local area network by following all steps in the following sections:
•
Establishing a serial connection to the device.
•
Logging in to the serial console port.
•
Configuring the IP addresses.
NOTE
Once an Ethernet connection is established, the device can be accessed by remote connection using any
of the available management tools, such as Telnet or Web Tools.
•
Establishing an Ethernet connection to the device.
2. Reconnect the transceivers and cables to the port blades.
NOTE
The ports and cables used in trunking groups must meet specific requirements. For a list of these
requirements, refer to the Brocade Fabric OS Administration Guide.
a) Position one of the transceivers so that the key is oriented correctly to the port and insert the transceiver into the
port until it is firmly seated and the latching mechanism clicks.
b) Select the cable that corresponds to the port and position it so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the transceiver. Insert the cable into the transceiver until the latching
mechanism clicks.
c) Repeat step a and step b for the remaining ports.
d) Organize the cables as required.
NOTE
Do not route cables in front of the air exhaust vents.
53-1002177-19
148
Broadcom

Broadcom Brocade DCX 8510-4 Backbone Specifications

General

Brand	Broadcom
Model	Brocade DCX 8510-4 Backbone
Category	Network Hardware
Language	English