53-1002177-19 Hardware Installation Guide
Brocade DCX 8510-4 Backbone Hardware Installation Guide
3. If applicable, lock the wheels of the lift.
4. Carefully lift the device and slide it into the rack.
5. Secure the device to the rack with six 10-32 screws with washers, three screws on each side (refer to the following
figure). Tighten the screws according to specifications under Torque requirements.
NOTE
Screws, clip nuts, and retainer nuts for securing the device to the equipment rack are included in the device
hardware accessory kit.
Figure 17: Brocade device with 18-24 in. (45.72 to 60.96 cm) kit installed in rack
1. 10-32 x .63 in.(1.60 cm) Phillips screw with square cone washer for racks that have rails with round holes
NOTE
For rails with round holes, use the clip nuts on the front rails for securing 10-32 screws. For rails with square
holes, use the retainer nuts (refer to Figure 7). Also refer to Figure 8.
6. Reinstall the device door if removed. Refer to procedures for removing and replacing the device door in this guide.
Installing the Device in a 27-31-Inch Rack (XBR-DCX4S-0121)
Use the following instructions to install the device in a rack with rail-to-rail depth of 68.58 to 78.74 cm (27 to 31 in.). Be
sure to use the 27-31 in. 8U Chassis Airflow Diversion and Port Side Exhaust Kit for Four-Post Rack (XBR-DCX4S-0121)
for this installation.
53-1002177-19
43
To Next Page
Loading...
Need help?
General