Broadcom Brocade DCX 8510-4 Backbone - Revision History

53-1002177-19 Hardware Installation Guide Brocade DCX 8510-4 Backbone Hardware Installation Guide
Revision History
53-1002177-19; 2 June 2020
The following changes have been made:
• Removed the "Brocade DCX 8510 Technical Specifications" section from this guide. The technical specifications are
provided in a separate guide.
• Modified the following sections in Chassis removal and replacement:
– Removed the "Verifying the PID mode" section from the "Initial setup and configuration" section as it is no longer
necessary for configuration.
– Recording critical device information – Revised the introduction to using critical information checklist, removed the
note to run the supportShow command, removed the -sw option from the step to enter the ipAddrShow command,
and added more information to the step to enter the supportShow command.
– Reconnecting the system to the network and fabric – Revised Step 1 to include references to sections in "Initial
configuration" for connecting a serial cable, establishing a serial connection, configuring IP addresses, and
establishing an Ethernet connection to the device.
– Verifying correct operation of system – Moved this section to after Reconnecting the system to the network and
fabric.
– Verifying correct configuration of the fabric – Added a step to modify the SCC policy for a fabric, if one exists, to add
the WWN of the new chassis.
• Corrected the torque requirements in the following sections of "Installing the 8U Chassis Airflow Diversion or Port Side
Exhaust Kit for Four-Post Racks (XBR-DCX4S-0121 and XBR-DCX4S-0130)":
– "Installing device in 18-24 inch rack (XBR0DCX4S-0130)"
– "Installing device in 27-31 inch rack (XBR-DCX4S-0121)"
53-1002177-19
173
Broadcom