Broadcom Brocade DCX 8510-4 Backbone User Manual

53-1002177-19 Hardware Installation Guide Brocade DCX 8510-4 Backbone Hardware Installation Guide
•
Use Electronic Industries Association (EIA) standard racks to install a modular device in a 19 in. Provide a space that
is 8 rack units (8U) high, with a rail-to-rail depth of 27-31 in.(68.58 to 78.74 cm). 1U is equal to 4.45 cm (1.75 in.).
•
Before mounting your device, review any specific installation and facility requirements in the Hardware Installation
Guide for the device.
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation
Guide.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are
installing into the rack.
Time and Items Required
Allow approximately one hour to unpack and install a device in a rack.
The following tools are required to install the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks (XBR-
DCX4S-0120).
•
Torque wrench with No. 2 Phillips screwdriver tip
•
Flathead screwdriver
•
Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg (250 lbs).
Parts List
The following parts are provided with the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks (XBR-DCX4S-0120).
NOTE
Not all parts may be used with certain installations depending on the device type.
53-1002177-19
51
Broadcom

Broadcom Brocade DCX 8510-4 Backbone Specifications

General

Brand	Broadcom
Model	Brocade DCX 8510-4 Backbone
Category	Network Hardware
Language	English