53-1002177-19 Hardware Installation Guide
Brocade DCX 8510-4 Backbone Hardware Installation Guide
6. Secure the device to the equipment rack racks with six 10-32 x .63 screws with square-cone washers, three screws on
each side. Tighten the screws to a torque of 92 cm-kg (80 in-lb). See the following figure.
Figure 28: Chassis Installed in Equipment Rack
1. 10-32 x .63 in. (1.60 cm) Phillips Screw with Square Cone Washer
7. Reinstall the device door. For instructions, see procedures for removing and replacing the device door in this guide.
53-1002177-19
55
To Next Page
Loading...