188
COOLING SYSTEM
PRESSURE RELIEF VALVE SERVICING
Inspection
Inspect all parts for cracks, heat damage, or signs
of corrosion. Replace damaged parts. Clean
debris from housing and parts.
Assembly
Assembly is the reverse of disassembly. Pay
close attention when performing the following
additional tasks.
Install a new plunger seal squarely over ridge in
housing.
Apply a light coat of Triple-Guard grease to a new
cover o-ring and place in groove in housing.
Install valve assembly into housing.
Tighten cover screws to a torque of 60 to 84 in.
lbs. (7 to 9.5 N·m).
Pressure Relief Valve Assembly Components 002442
1. Plunger seal
2. Cover o-ring
002458
To Next Page
Loading...
