196
POWERHEAD
POWERHEAD REMOVAL
3-Cylinder Models
Remove lower motor covers. Refer to Lower
Cover Removal on p. 54.
Disconnect power trim connectors.
Remove pin and washer from shift rod lever to
release the lower shift rod.
Remove six retaining screws and exhaust relief
muffler.
Install Lifting Fixture, P/N 396748, on flywheel and
seat the three screws completely.
Be sure to use only the 1 1/8 in.
(short) screws, P/N 398067, included with the
tool to avoid damage to electronic compo-
nents under the flywheel.
Fasten appropriate chain hook to eye of tool and
support weight of powerhead with hoist.
A WARNING
Protect against hazardous fuel spray.
Before starting any fuel system service,
carefully relieve fuel system pressure.
Refer to Relieving Fuel System Pressure
on p. 146.
To prevent accidental starting while ser-
vicing, twist and remove spark plug leads.
002152
1. Shift rod pin 002013
002159
1. Lifting fixture
2. 1 1/8 in. screws
002098
To Next Page
Loading...
