EasyManuals Logo

BRP EVINRUDE E-TEC E90DSLAA Series User Manual

BRP EVINRUDE E-TEC E90DSLAA Series
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
72
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
TPS Calibration
TPS Calibration synchronizes throttle plate open-
ing with throttle position sensor voltage.
Refer to TPS Calibration on p. 118.
Perform TPS Calibration after replacing or adjust-
ing any throttle body or throttle linkage parts.
Idle Speed Control
Use the Idle Adjust function to increase or
decrease IN GEAR IDLE speed. This adjustment
offsets the basic EMM programming and will not
set an absolute fixed speed. After the offset is
changed, the EMM continues to control engine
operation normally. Engine idle speed is not fixed.
Fuel Injector Servicing
All E-TEC fuel injectors use software program-
ming to compensate for variations in fuel flow.
Each injector and its location on the outboard is
identified by the EMM. DO NOT install an injector
without updating the compensation software.
To install a service injector, click the “Replace”
button on the Injector Coefficients screen and
select the file for the replacement injector. Refer to
Fuel Injector Service on p. 150.
1. TPS Calibration button 008581
1. Idle adjustment 008580
1
1
008573

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BRP EVINRUDE E-TEC E90DSLAA Series and is the answer not in the manual?

BRP EVINRUDE E-TEC E90DSLAA Series Specifications

General IconGeneral
BrandBRP
ModelEVINRUDE E-TEC E90DSLAA Series
CategoryEngine
LanguageEnglish

Related product manuals