Installation Manual Version 001 BRUKER 11 (167)
3
Safety
Considerations 3
Before Mounting the Automatic Sample Changer 3.1
Make sure the magnet is firmly secured to its base in order to prevent the instru-
mentation from tipping over.
While Mounting the Column 3.2
When assembling the column, do not tighten the top fastening ring too hard, as
this may cause damage to the column surfaces.
When fixing the column to the magnet, mount both bottom arms to prevent ob-
struction when manipulating or changing probes.
When handling tools, screws, or any metallic parts beware of the strong magnetic
field.
During Operation 3.3
Excessive tension of the magazine belt will damage the belt and wheel bearings.
(Refer to "
Cabinet and Magazine Belt Adjustment" on page 31 for adjustment
of the tension of the magazine belt).
Beware of the strong magnetic field while working around the magnet. Keep all
metal objects, such as tools, screws, or any metallic parts away from the magnet.
Remove any mechanical watches or metallic objects while working around the
magnet.
When the Automatic Sample Changer is running, avoid putting hands or objects in
the path of the arm, magazine belt or pinchers, as this may cause personal injury
or damage to the equipment.
Potentially Hazardous Areas 3.4
The symbol shown on the left indicates a potentially hazardous area (ISO 3864;
DIN 40008).
The symbol is placed on the following areas of the Automatic Sample Changer:
1. On the upper left half of the front side (side that is away from the magnet) of
the vertical cylinder. Warning: When the sample changer is in operation keep
!
To Next Page
Loading...
Need help?
General