Bruker B-ACS 60 - Pneumatic Cylinder Settings; Figure 5.6. Top View of the Right Wheel and Tension Adjusting Mechanism

Pneumatic Cylinder Settings
Installation Manual Version 001 BRUKER 35 (167)
Figure 5.6. Top View of the Right Wheel and Tension Adjusting Mechanism.
Pneumatic Cylinder Settings 5.4
The speed of both the vertical and horizontal cylinder can be varied by regulating
the outlet air flows of the cylinder supply connections. A small needle valve is fit-
ted on the exhaust outlet of each of the magnetic valves 1, 2, 4, and 5 (Figure
5.7.). The needle valves can be manually set to change the linear speed of the
cylinder (by using a screwdriver).
Additionally the ORIGA horizontal cylinder is provided with two „end of
course“regulation needle valves to set the slowing down of the cylinder when
reaching the end position (see Figure 5.8.
).
CABINET
RIGHT
CARROUSEL
WHEEL
TENSION
ADJUSTING
SCREW