Installation Manual Version 001 BRUKER 151 (167)
500 MHz and 600
MHz SAG Magnets B
Introduction B.1
This is a supplement to the BRUKER Automatic Control Systems installation man-
ual - mounting instructions (chapter 4) for the mounting of a sample changer on a
500 MHz Magnet with Vibration Dampers (figure B.1).
Figure B.1. 500 MHz Magnet
Mounting Instructions B.2
Preparation B.2.1
Prepare the light barrier assembly, cabinet and column assembly as described in
chapter 4 of this installation manual.
Ensure that you have all of the parts required to mount the B-ACS sample chang-
er to the 500 MHz magnet, as shown in figure B.2.
Connect the adjustable arm assemblies (figure B.2) to the round column part just
below the cabinet (figure B.6), and tighten them loosely. (Note: the larger two seg-
ment ring is the column end of the assembly).
To Next Page
Loading...