Installation
Installation Manual Version 001 BRUKER 111 (167)
Figure 12.2. Placing the Bar Code Reader Unit on the Cabinet
Mounting the Bar Code Reader Unit on the Cabinet
Mount the Bar Code Reader Unit over the cabinet and sample belt carrousel,
aligning the four hexagon socket head cap screws over the holes in the top of the
cabinet (figure 12.2
). Tighten the screws slightly, allowing for some movement of
the reader unit for later adjustment.
Adjust the reader unit to ensure a uniform contact of the wheels on the bar code
sleeve (see figure 12.3
). The sample position between the guide wheels must be
checked carefully. Move the Unit forwards or backwards, then left or right to adjust
the position.
Connect the end of the bar code detection cable to the bar code detection board.
4 sockets for mounting
the bar code reader. Align
with sockets on top of Ca-
binet and secure with he-
xagon screws
Light Barrier at
Magazine
Top of Cabinet Assembly
Hole for
Pressure Reducer
Column
Assembly
Rectangle Slot
Magazine Belt
To Next Page
Loading...