Installation Manual Version 001 BRUKER 27 (167)
5
Settings and
Adjustments 5
General 5.1
This chapter will lead you through the mechanical settings, fine adjustment proce-
dures, pneumatic cylinder setting, and final setup of the automatic sample chang-
er. These adjustments should be made only after the sample changer has been
mounted in accordance with the instructions in chapter 4.
Mechanical Settings 5.2
Before making the following adjustments, make sure that the light barrier cylinder
has been properly fitted on the top of the shim system and that cable #5 is con-
nected to the Cable and Pneumatic Hose Connection Panel (refer to"
Connecting
the Hoses and Cables" on page 22).
Important:
Pull the CPU board and the interface board half ways out (Figure
5.1.).
To Next Page
Loading...