Installation Manual Version 001 BRUKER 157 (167)
Figures
1 Declaration of Conformity 7
2Introduction 9
3 Safety Considerations 11
Figure 3.1. Extreme Temperature Warning ...........................................12
4 Mounting Instructions 13
Figure 4.1. Location of Adjustable Arm Assemblies ..............................13
Figure 4.2. Magnet with BOSS Shim System Already Mounted .............14
Figure 4.3. Light Barrier for the Shim System .......................................15
Figure 4.4. Front view of the Automatic Sample Changer .....................16
Figure 4.5. Column Assembly ...............................................................18
Figure 4.6. Adjustable Arm Assembly for Magnets without N2 Tower .....19
Figure 4.7. Adjustable Arm Assembly for Magnets with N2 Tower ..........19
Figure 4.8. Arrangement of Arm and Cabinet Assemblies ......................20
Figure 4.9. Position of the Pneumatic Arm on the Column ....................21
Figure 4.10. Rear View of the Automatic Sample Changer ......................23
Figure 4.11. Partial Front View of Column and Cabinet ...........................24
Figure 4.12. Pneumatic Connections to Magnet and Console. ................25
Figure 4.13. Cable and Pneumatic Hose Connection Panel ....................26
5 Settings and Adjustments 27
Figure 5.1. Cabinet View Showing Boards and Pneumatic Assembly ....28
Figure 5.2. Security Switch ..................................................................28
Figure 5.3. Sample in Pincher on Top of Shim System ..........................29
Figure 5.4. Sample in Pincher on Tip of Magazine Belt .........................30
Figure 5.5. Mounting the Vertical Cylinder ............................................32
Figure 5.6. Top View of the Right Wheel and Tension Adjusting
Mechanism. ........................................................................35
Figure 5.7. Outlet Needle Valves on the Cylinder Supply Connections ..36
Figure 5.8. ORIGA Horizontal Cylinder Pneumatic Setting .....................36
6 Operating Instructions 37
Figure 6.1. Front Panel of Automatic Sample Change ...........................37
7 Software Commands 41
8 Special Tools 55
9 Operator Maintenance 57
To Next Page
Loading...