2 From Settings, click Management.
3 Click the settings icon ( ) to the right of “Configuration Management”.
4 Select “Save current configuration to a USB drive”.
5 From “Target USB Drive”, select the USB memory device that is connected to the USB 3.2 Gen 1 port on the
LinkStation, then click Execute.
6 The “Confirm Operation” screen will open. Enter the confirmation number, then click OK.
7 The settings will be saved. When saving settings is finished, click OK.
Troubleshooting:
If the settings are not saved to the USB memory device successfully, you may receive an error message such as “The
specified operation cannot be executed.”. Verify:
• The USB memory device has a capacity of 1 GB or more.
• The USB memory device is not write-protected.
Applying Settings
The saved settings can be applied to a different Buffalo NAS device of the same series. If applying settings to
another Buffalo NAS device, the unit’s current firmware version will be changed to the version used to save the
settings.
1 Insert the USB memory device with the saved settings into a USB 3.2 Gen 1 port on the LinkStation.
2 From Settings, click Management.
3 Click the settings icon ( ) to the right of “Configuration Management”.
153
Chapter 7 Settings Backup/Restoration
To Next Page
Loading...
