4 When the I41 message appears on NAS Navigator2, press the function button.
5 The LinkStation will initialize the settings. The I37 message will appear on NAS Navigator2 while settings are
being initialized. When the initialization is finished, the LinkStation will restart automatically.
Dismount the USB memory device before unplugging it. Refer to the “Dismounting Drives” section in chapter 3 for
the procedure on dismounting drives.
Resetting the Administrator Password
If you forget the admin username or password and cannot log in to Settings, or incorrect network settings are
configured and Settings becomes inaccessible, initialize these settings by holding down the init button (refer to
the “Diagrams” section in chapter 1) for 10 seconds. This will typically reset the admin username and password, IP
address settings other than Wake-on-LAN, and SSL to their factory default values. The I23 message will appear on
NAS Navigator2 while settings are being initialized.
This button can be disabled in Settings; to do so, navigate to Management > Restore/Erase > Edit under “Init Button
Settings”, then select “Keep current admin username and password” and click OK.
158
Chapter 7 Settings Backup/Restoration
To Next Page
Loading...
