1 Move the power switch to the “Off” position to turn off the LinkStation.
2 Press and hold the function button while moving the power switch to the “On” position to power on the
LinkStation.
3 When the I41 message appears on NAS Navigator2, press the function button to start firmware recovery.
4 The LinkStation will repair the firmware. The I37 message will appear on NAS Navigator2 while the firmware is
being repaired. When firmware recovery is finished, the LinkStation will restart automatically.
Note: After firmware recovery, the firmware version will remain unchanged.
198
Chapter 10 Drive Replacement and Troubleshooting
To Next Page
Loading...
