Burkert 8681 - 24 REPLACEMENT OF COMPONENTS AND MODULES; Replacement Safety Instructions

157
Replacement of Components and Modules
24 REPLACEMENT OF COMPONENTS AND
MODULES
If components or modules need to be replaced for maintenance or service reasons, please observe the fol-
lowing notes and descriptions.
Devices that are used in the potentially explosive atmosphere may only be repaired by the
manufacturer!
24.1 Safety instructions
DANGER!
Danger of explosion in a potentially explosive atmosphere (only in the event of a fault as zone 2)!
` Opening the hood or the housing in a potentially explosive atmosphere is only allowed in a not energised
state!
WARNING!
Risk of injury due to electric shock!
` Beforereachingintothesystem(exceptfortheTeachprocedureinanon-explosiveatmosphere)switch
othepowersupplyandsecureittopreventrestarting!
` Observeapplicableaccidentpreventionandsafetyregulationsforelectricalequipment!
Risk of injury from high pressure!
` Beforelooseninglinesandvalves,turnothepressureandventthelines.
Risk of injury due to improper maintenance work!
` Maintenance work may be carried out by trained technicians only and with the appropriate tools!
Risk of injury from unintentional activation of the system and uncontrolled restart!
` Secure system against unintentional activation.
` Following maintenance, ensure a controlled restart.
NOTE!
IP65/IP67protection
During all work steps, make sure that IP65 / IP67 protection is once again ensured for the control head
when used as intended!
Openingandclosingthecontrolhead
Duringallworkwhichrequiresopeningandclosingofthecontrolhead,alsoobservethenotesandcom-
ments in chapter “8OpeningandClosingtheHousing”!
english
Control Head Type 8681