Burkert 8681 - 26 Packaging and Transport; 27 Storage; 28 Disposal

164
Packaging and Transport
26 PACKAGING AND TRANSPORT
NOTE!
Transport damage!
Inadequately protected devices may be damaged during transportation.
` During transportation protect the device against moisture and dirt in shock-resistant packaging.
` Avoidtheeectsofheatandcoldwhichcouldresultintemperaturesaboveorbelowthepermittedstor-
age temperature.
Approved non-return and reusable transport containers are used for the transport ex factory and storage of
the control head. Preferably use this packaging.
If the control head is stored for further pre-assembly of a system, for example as part of a process valve
module, kindly make sure:
•
thatthecontrolheadhasbeensecuredsuciently!
•that the electrical and pneumatic lines cannot be accidentally damaged and / or cannot indirectly damage
the control head!
•that the control head is not used as support during packaging and transport!
•that the control head is not exposed to any mechanical stress!
27 STORAGE
NOTE!
Incorrect storage may damage the device.
` Store the device in a dry and dust-free location!
` Storage temperature: -20 ... +65 °C.
Kindly make sure that the devices, following storage at low temperatures, are heated slowly to room tem-
perature before you carry out any assembly work on the devices or start operation of the devices!
28 DISPOSAL
→ Dispose of the device and packaging in an environmentally friendly manner.
NOTE!
Damage to the environment caused by device components contaminated with media.
` Observe the relevant disposal and environmental protection regulations.
Note:
Observe the national waste disposal regulations.
english
Control Head Type 8681